Using the ALES VPN

This guide describes how to set up the ALES VPN service.


Note: You must register your CCID with ALES-IT  prior to attempting to connect with the VPN client


  1. Go to https://vpn.ualberta.ca

  2. Click the “How to Connect to the University of Alberta VPN Service” guide at the bottom of the page.

  3. Under “Procedure”, download the proper installer for your computer & install the software.

  4. Open your new VPN client, and type vpn.ualberta.ca into the text box, and click “connect

  5. Enter in your CCID@ales and your CCID password, and click “OK”.

    The @ales is VERY important. If you just enter your CCID you will not be able to access ALES resources (as you will not be on the correct VPN).

  6. You should now be connected. The following message will pop up in the corner of your screen:

  7. To verify if you are connected to the correct VPN:

    1. Expand the list of active programs in your task bar (on Windows)

    2. Right click the “AnyConnect” icon as shown in the following screen shot

    3. Click “Open AnyConnect”

    4. You will see the screen shown below. Click the “gear” (highlighted in the red box)

    5. On the next screen that appears, verify that you have a “Client (IPv4)” address between 10.0.35.2 and 10.0.35.254